Overview (Fig. A); On/Off Switch - Black & Decker MT3000K Anleitung

f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are less
likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc.,
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed. Use of the power tool
for operations different from those intended could result
in a hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
Additional safety instructions for drill/screwdrivers
Before drilling into walls, floors or ceilings, check for the
x
location of wiring and pipes.
Avoid touching the tip of a drill bit just after drilling,
x
as it may be hot.
Additional safety instructions for sanders
Always wear a dust mask whenever sanding.
x
Thoroughly remove all dust after sanding.
x
Take special care when sanding paint which is possibly
x
lead based or when sanding some woods and metal
which may produce toxic dust:
- Wear a dust mask specifically designed for protection
against lead paint dust and fumes and ensure that persons
within or entering the work area are also protected.
- Do not let children or pregnant women enter the work
area.
- Do not eat, drink or smoke in the work area.
- Dispose of dust particles and any other debris safely.

Overview (fig. A)

This tool includes some or all of the following features.
Motor unit

1. On/off switch

2. Lock-on button
3. Head release button
4. Bit storage
Screwdriver head
5. Forward/reverse switch
6. Bit holder
Sander head
7. Sanding base
8. Sanding base tip
9. Dust extraction outlet
Preparation head
10. Mounting shaft
11. Clamp plate
12. Allen key storage
Fig. A
In addition, this tool is supplied with some or all of the
following accessories.
13. Scraper head
14. Blade cover
15. Rigid parallel blade
16. Flexible parallel blade
17. Screw driver bit
18. Drill bits
19. Sanding sheet
20. Abrasive pad
21. Dust extraction adaptor
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting and removing tool heads (fig. B)
The different tool heads can be easily exchanged.
To remove a tool head, depress the head release button
x
(3) and take the head off the tool.
To fit a tool head, line it up with the tool as shown and
x
push it onto the tool until it snaps into place.
Fitting and removing a screwdriver bit (fig. C)
Pull the sleeve (22) backward.
x
Insert the bit shaft into the bit holder (6) as far as it will go.
x
Release the sleeve to secure the bit.
x
To remove the bit, pull sleeve backward and pull the bit
x
out firmly.
This tool is supplied with a screwdriver bit in the bit storage (4).
To remove the screwdriver bit from the bit storage press
x
the bit down into the bit holder recess (4), then lift the bit
out.
To store the screwdriver bit, firmly push it into the storage.
x
ENGLISH
5