Hoshizaki FM-170AFE Installationsanleitung Seite 2

IMPORTANT
1. In order to carry out safe and proper installation
of the product, please read this booklet
carefully beforehand and follow the instructions
contained within.
2. On completion of the installation, start up the
icemaker to check for any abnormalities, and
instruct the user on how to use and maintain
the icemaker in accordance with the
Instruction Manual.
3. This booklet should be handed over to the user
after the installation and be preserved by the
user together with the Instruction Manual for
any further consultation that may be
necessary.
WARNING
The installation must be carried out by
qualified personnel, in accordance with current
regulations, according to the manufacturer's
instructions.
1. UNPACKING
WARNING
Children should not be allowed in reach of the
packaging elements (plastic bags and expanded
polystyrene) as they are potential sources of
danger.
CAUTION
1. Do not lift or manoeuvre the carton by using
the shipping bands.
2. Remove shipping carton, tape(s) and packing.
If packing material is left in the icemaker, it
will not work properly.
Power Supply Cord
Top Panel
Front Panel
Air Filter
Louver
Fig. 1
Note: This icemaker needs a Storage Bin. The
1) After removing the packaging, make sure that the
2) Remove the shipping tape holding the panels.
3) Remove the Front, Top and Side Panels. See Fig.
4) Remove the package of accessories, and check
5) Remove the protective plastic film from the panels.
Operation Panel
2. LOCATION
1
recommended Storage Bin is HOSHIZAKI ICE
STORAGE BIN, Model B-300SF(PF) or B-
500SF(PF) with Top Kit - 8C, B-700SF(PF) with
Top Kit - 22C, or B-900SF(PF) with Top Kit -
22C and Top Kit - 8C.
icemaker and the Storage Bin are in good condition.
If in doubt, please do not use the equipment but
apply to professionally qualified personnel. See the
instruction sheet attached to the Storage Bin for its
unpacking and installation guidelines.
2.
Front Panel
Top Panel: Remove the screw(s). Lift off.
Front Panel: Remove the screw. Lift up and
pull toward you.
Side Panel: Remove the screw.
slightly toward you, and lift off.
Fig. 2
the contents:
a) Installation Kit
Inlet Hose
Outlet Hose
b) Mounting Bracket
If the icemaker is exposed to the sun or to heat,
remove the film after the icemaker cools.
IMPORTANT
1. This icemaker is not intended for outdoor use.
Normal operating ambient temperature should
be within 5°C to 40°C. Normal operating water
temperature should be within 5°C to 35°C.
Operation of the icemaker, for extended
ENGLISH
Top Panel
Side Panel
Pull
1
2
2