Transport And Storage - Stahl 9475/33-08 0 Serie Betriebsanleitung

Transport and storage

Device-specific data
Settings
Module
Diagnosis messages
Signal
Power error control
Behaviour in case of error
Ambient conditions
Ambient temperature
Storage temperature
Maximum relative humidity
Semi-sinusoidal shock 
(IEC EN 60068-2-27)
Sinusoidal vibration 
(IEC EN 60068-2-6)
Mechanical data
Degree of protection (IEC 60529)
Module enclosure
Fire resistance (UL 94)
Pollutant class
Dimensions
Indication
LED indication
Module requires maintenance
Operating state
Group error
Function indication
Retrievable parameters
Error indication
Module status and alarms
Signal errors for each channel
Signal status bit
Wire breakage output
Short circuit output
Mounting / installation
Mounting orientation
Mounting type
8 Transport and storage
 Transport and storage are only permitted in the original packaging.

The devices must be stored in a dry place and vibration-free.
8
Digital Output Module for Zone 2
9475/33-08-.0
ON / OFF
ON / ON without test current / OFF
ON / OFF / hold last value
-40 ... +75 °C
-40 ... +80 °C
95 % (without condensation)
15 g (3 shocks per axis and direction)
1 g in the frequency range 10 ... 500 Hz
2 g in the frequency range 45 ... 100 Hz
IP20
polyamide 6GF
V2
corresponds to G3
L = 128 mm, W = 96.5 mm, H = 67 mm
LED "M/S", blue
LED "RUN", green
LED "ERR", red
Manufacturer, Type, hardware revision, software revision, serial number
• Internal bus error primer / redundant
• No response from IOM
• Configuration does not correspond to module
• Hardware error
• Excess temperature
• Slot error
• Module requires maintenance
"0" = output high-impedance / "1" = output is supplied
> 12 kΩ 
(with deactivated test current can be detected only if the output is switched on)
< 30 Ω (response range 30 ... 60 Ω) 
(can be detected only if the output is switched on)
horizontal or vertical (see chapter 9.3)
on 35 mm DIN rail LV 35/15 (DIN EN 60715)
218140 / 9475612310
2013-05-08·BA00·III·en·00