Assembly Instructions - Rotel OSCILLATINGSTANDVENTILATOR741CH1-2 Gebrauchsanweisung

• ASSEMBLY INSTRUCTIONS

o The fan is packaged with its base and/or other parts unattached. You must attach
them before operating the fan.
o WARNING: Never operate without its base and/or other parts attached. Do operate
the fan only in upright position; any other position could create a hazardous situa-
tion.
o Nos. 4 and 7 are for transport purposes and are removed before assembly.
Assemble sequence of the base and other parts as follow:
o
 Unpack the fan and remove all the parts from the packaging.
 Use the bend bolt and the press plate (14) provided to attach the stand post
(12) assemblies to the base (13).
 Adjust the lift pole to the desired length, then lock it with the locknut for lifting
(11).
 Loosen the locknut for switch case (10) and insert the lift pole into the hole lo-
cated on the bottom of the switch case (9) in place, then fasten the locknut
tightly (10).
 Take off the motor shaft cover (7) from the
fan head and revolve the triangle screw (5)
off, then take off the fan tie (4) on the back
grill (6) and let three columns into the three
holes in place fully. Finally tighten the trian-
gle screw (5) clockwise.
 Let the notch on the back of the big fan
blade (3) stuck in the stopper pin of the mo-
tor shaft, and then tighten the small fan
blade (2) counterclockwise.
 To attach the front grill (1) to the back grill (6), use the grill ring carefully to hold
them together and fasten the grill ring with the screw provided.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
26