Assembling The Device - Silvercrest SSVF 45 A1 Bedienungsanleitung

5. Assembling the
device
1. The base plate 15 and the L-shape
screw 16 are already fitted to the lower
end of the pedestal 13 on delivery.
Loosen the L-shape screw and remove
both parts.
2. Place the pedestal 13 on the base 14.
From the underside of the base, place the
base plate 15 and screw it to the pedes-
tal with the L-shape screw 16.
3. Unscrew the circlip 12 a little (anti-
clockwise). Pull the inner pole 11 out of
the pedestal 13 a little and screw the
circlip 12 back in place (clockwise).
4. Place the top part (control unit 8 and
fan motor 7) on the inner pole 11.
Tighten the locking screw 10.
8
GB
5. The screw ring 4 is mounted on the fan
motor 7 on delivery. Loosen it.
6. Place the rear protective grid 5 on the
fan motor 7. Pay attention to the follow-
ing:
- The small hole for the connecting
screw 18 is at the bottom.
- The two smaller slots in the middle of
the protective grid are placed on the
ridges on the fan motor.