FCC Information (nur USA)
This device complies with Part 15 of the FCC Re-
sults. Operation is subject to the following two
conditions:
1.
This Device may not cause harmful interface,
and
2.
This device must accept any interference re-
ceived, including interference that may cau-
se undesired operation.
Note: This equipment has been tested and
found to comply with the limits for CLASS B di-
gital device, pursuant to Part 15 of FCC Rules.
These limits are designed to provide reasonab-
le protection against harmful interference when
the equipment is operated in a commercial
environment. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encou-
raged to try correct the interference by one or
more of the following measures:
1.
Reorient or relocate the receiving anten-
na.
2.
Increase the separation between the
equipment and receiver.
3.
Connect the equipment into an outlet on a
circuit different from that to which receiver
is connected.
4.
Consult the dealer or experienced radio/
TV technician for help.
WARNING
Changes or modifi cations not expressly approved
by the manufacturer could void the user's authori-
ty to operate the equipment.
CAUTION
Exposure to Radio Freqency Radiation.
Antenna schall be mounted in such a manner to
minimize the potential for human contact during
normal operation. The antenna should not be con-
tacted during operation to avoid the possibility
of exceeding the FCC radio frequency exposure
limit. The minimum separation distance of 20 cm
from the antenna to the body of user required.
FCC Information (USA)
39