Oil Level - Black+Decker CS1825ST1 Bersetzung Der Originalanweisungen

ENGLISH
The operator should consider access to the tree limb and the
direction of fall. The tree branch is liable to swing towards
the tree trunk. In addition to the user bystanders, objects and
property below the branch will be at risk.
To avoid splintering, make the first cut in an upward
u
direction to a maximum depth of one third the diameter of
the branch.
Make the second cut downwards to meet the first.
u
Logging (fig. S, T & U)
How you should cut depends on how the log is supported. Use
a saw horse whenever possible.
Always start a cut with the saw chain running and the spiked
bumper (20) in contact with the wood (fig. S). To complete
the cut use a pivoting action of the spiked bumper against the
wood.
When supported along its whole length:
Make a downward cut, but avoid cutting the earth as this
u
will blunt your saw chain quickly.
When supported at both ends:
First, cut one third down to avoid splintering and second,
u
cut up to meet the first cut.
When supported at one end:
First cut one third up to avoid splintering and second, cut
u
down to prevent splintering.
When on a slope:
Always stand on the uphill side.
u
When attempting to cut a log on the ground (fig. T):
Secure the workpiece using chocks or wedges. The user
u
or a bystander should not steady the log by sitting or
standing on it. Make sure that the saw chain does not
contact the ground.
When using a saw horse (fig. U):
This is strongly recommended whenever possible.
Position the log in a stable position. Always cut on the
u
outside of the saw horse arms. Use clamps or straps to
secure the workpiece.
Limbing (fig. V)
Removing the branches from a fallen tree. When limbing,
leave larger lower limbs to support the log off the ground.
Remove the small limbs in one cut. Branches under tension
should be cut from the bottom of the branch towards the top to
avoid binding the chain saw.
Trim limbs from opposite side keeping tree stem between you
and saw. Never make cuts with saw between your legs or
straddle the limb to be cut.
14
(Original instructions)
Troubleshooting
Problem Possible cause
Tool will not start Lock button not
pressed
Battery not fitted
Battery not charged
Battery not fitted
correctly
Chain does not stop Chain tension is too
within 2 seconds slack
when the tool is
switched off
Bar/chain appear hot/ Oil tank empty
smoking
Oil hole blocked on
chain bar
Chain tension is too
tight
Guide bar sprocket
nose needs greasing
Chainsaw does not
Chain on backwards
cut well
Chainsaw not using Debris in tank
oil
Oil hole in cap blocked
Debris in chain bar
Debris in oil outlet
Chainsaw stops
Battery depleted
suddnely during use
Battery too hot
Voltage limit protection
Maintenance
Regular maintenance ensures a long effective life for the tool.
We recommend you make the following checks on a regular
basis.
Warning! Before performing any maintenance on power tools:
Switch off and disconnect the tool from the mains supply.
u

Oil level

The level in the reservoir should not be allowed to fall below
a quarter full.
Possible solution
Press the lock button
Fit the battery
Charge the battery
Remove then re-fit the
battery
Check chain tension
Check oil tank level
Clean oil holes (21 - fig.
E) and clear the groove
around the edge of the
chainbar.
Check chain tension
Oil the guide bar
sprocket nose
Check/modify chain
direction
Sharpen
Empty oil from tank and
replace
Remove debris from
hole
Remove debris and
clean the chain bar
Remove debris
Re-charge battery if
required
Leave the battery to
cool for atleast 30
minutes before
proceeding or charging
Restart the chainsaw.
Let the tool work at its
own pace. Do not
overload