Troubleshooting; Troubleshooting Schedule - Husqvarna Soff-Cut 150 Bedienungsanweisung

2. Make a note of the washers and other parts removed
and the order of assembly.
3. Slide the bronze bushing from inside the old front
guide wheel and insert into the new one.
4. Slide the bronze bushing from inside the old rear
guide wheel and insert into the new one.
5. Install the new guide wheels using the same
shoulder bolts, lock nuts and plastic washers.
Half-inch wide guide wheels, not included with the saw,
are also available for use with ProEdge Blade XL6-
V500-D, when chasing ½ʺ wide saw cuts.
To lubricate the blade shaft bearings
• Lubricate the blade shaft bearings with 3 pumps of
grease.
For the correct type of grease, refer to
data on page 28 .

Troubleshooting schedule

WARNING: Troubleshooting causes risk of
injury because personnel does work in the
22
Maintenance of the engine
Refer to the operator's manual for the engine for
additional information about servicing of the engine. The
operator's manual for the engine also has information
about specifications, tune-up parts, engine warranty,
emission compliance, etc.
Technical

Troubleshooting

If you cannot find a solution to your problems in this
owner's manual, speak to your Husqvarna service
agent.
risk areas of the product. Be careful, prepare
the work and use common sense.
714 - 004 - 06.07.2021