ENGLISH
Problem
The compressor operates
continually.
The compressor operates
continually.
The compressor does not
start immediately after press‐
ing the "Fast Freezing", or af‐
ter changing the tempera‐
ture.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily.
The lamp does not work.
The lamp does not work.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
Possible cause
The door is not closed cor‐
rectly.
The Fast Freezing function is
switched on.
The compressor starts after a
period of time.
The appliance is not levelled.
You attempted to re-open the
door immediately after clos‐
ing.
The lamp is in stand-by
mode.
The lamp is defective.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the ambi‐
ent temperature is too high.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Solution
Refer to "Closing the door"
section.
Refer to "Fast Freezing func‐
tion" section.
This is normal, no error has
occurred.
Refer to installation instruc‐
tions.
Wait a few seconds between
closing and re-opening of the
door.
Close and open the door.
Contact the nearest Author‐
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature. Re‐
fer to "Control Panel" chap‐
ter.
Set a higher temperature. Re‐
fer to "Control Panel" chapter
and "Location" section.
This is correct.
21