First Use; Turning Off The Heater - Duronic FH2KW1 - Fan heater Bedienungsanleitung

Operating Instructions

FIRST USE

Upon first use, there may be a trace of smoke or odour when the unit is
switched on. This is normal and will fade away quickly.
TURNING THE HEATER ON
1. Connect the Power
Place the heater on a flat dry floor surface, within close proximity to a mains
plug socket. Plug in the power cable and switch on at the plug.
2. Switch on the Heater
Turn the Temperature Control Dial clockwise until you hear a click noise, this
means the temperature controller is on. The pilot light will glow. Adjust the dial
to the desired temperature level.
3. Select the Power Level
Turn on the Power Selection dial by selecting between 3 different levels: Cool
fan only / low heat (1200W) / high heat (2000W).

TURNING OFF THE HEATER

1. Turn the Power Selection Dial to the 'OFF' position.
2. Turn the Temperature Control Dial anticlockwise to the 'MIN'
position.
3. Switch off at the plug socket and remove the plug from the socket.
4. If you plan to store the heater away, allow it to cool down first beforehand.
9