Connecting Up - Xoro HTC 2220D Bedienungsanleitung

Description
OPEN/CLOSE
PLAY
STOP
MENU
V+
V-
CH+ / CH -
TV/AV
Power

Connecting Up

1. Connect the aerial or input source to the appropriate input socket at the rear of the set.
(see page 4).
2. Connect the small round plug on the power adaptor cable to the power input socket at
the rear of the set.
3. Connect the main cable between the power adapter and the main supply.
4. Switch the power on by pressing the POWER button on the front panel or the remote
control. The LED will show green.
5. Use the AV button on the front panel or the remote control to select which input source to
use :TV, PC-RGB, AV, S-video, SCART, DVB-T or DVD.
You can use the front panel control to adjust the volume or select a channel, as shown
below, or you may use the remote control (see page 7).
A. Analog TV tuner (for example: cable system)
After switched on and press the AV button repeatedly, till "TV" is displayed right
above on screen. Now the HTC 2220D is in TV Mode.
B. DVD-Player:
Switch on the unit and press the AV button repeatedly, till "DVD" is displayed right
above on screen. Now the HTC 2220D is in DVD Mode.
C. DVB-T mode:
Switch on the unit and press the AV button repeatedly, till "DVB" is displayed on
screen. Now the HTC 2220D is in DVB-T mode.
6. To switch the set off a short time, press the POWER button, the set will go into standby
and the LED will show red . lf you are not going to use the set for some time, switch the
power off completely by unplugging the mains cable .
Connecting Up
Function
DVD-Tray open/close
DVD play
DVD stop
LCD activate menu
Volume increase
Volume decrease
Change TV channel
Source
Power on / off button
5