Lippert ALANERA 10857-Serie Bedienungsanleitung Seite 10

• connect the end of the wiring harness to the electrical system of the
vehicle: this operation can differ greatly depending on the specific
electrical system that the unit must connect to. The connections
included in the standard wiring harness are:
DESCRIPTION
+12V DC
Ground
Safety alarm output
The wires must not be exposed, so the provided protection must
not be removed until the wires are inside the vehicle and
therefore protected by the shell of the vehicle itself.
If current is directly applied to the unit, the tread will move outwards: to
move the tread back in the closed position, a four-way switch or a DPCO
switch must be used to interrupt or invert the movement. To improve the
user's experience and reliability, the use of the
advised.
WARNING
The safety alarm output is connected to a N-C (normally closed)
switch inside the unit: this switch detects (opens) when the tread
of the step is not completely closed: this is a safety measure in
order to prevent the movement of the vehicle while the tread is
protruding from it, this feature must be active in the electrical
system by the means of an acoustic signal, alarm, light signal, or
preventing the ignition system to turn on.
for further documentation on the electrical connections, a
selection of the most common electrical diagrams, along with
spare parts lists, and electrical accessories, are available on
COLOR
red
Black
blue
brown
www.lippertcomponents.eu
SECTION AREA
1,5 mm²
1,5 mm²
0,5 mm²
0,5 mm²
control unit is
2020348929
9