Hama 00133755 Bedienungsanleitung Seite 2

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference.
1. Explanation of Warning Symbols and Notes
Risk of electric shock
This symbol indicates product parts energized
with a dangerous voltage of sufficient magnitude
to constitute a risk of electric shock.
Warning
This symbol is used to indicate safety instructions
or to draw your attention to specific hazards
and risks.
Note
This symbol is used to indicate additional
information or important notes.
2. Package Contents
• Charger (USB-A), QC 3.0, 2.0
• USB-A – USB-C charging cable
• These operating instructions
3. Safety Notes
• Protect the product from dirt, moisture and
overheating and use it in dry rooms only.
• Do not drop the product and do not expose it to
any major shocks.
• Do not operate the product outside the power
limits given in the specifications.
• Do not modify the device in any way. Doing so
voids the warranty.
• Do not continue to operate the device if it
becomes visibly damaged.
• Use the product for its intended purpose only.
• Keep this product, as all electrical products, out of
the reach of children!
• Do not use the product in the immediate vicinity
of heaters or other heat sources or in direct
sunlight.
• Lay all cables so that they do not pose a tripping
hazard.
• Do not bend or crush the cable.
• Always pull directly on the plug when
disconnecting the cable, never on the cable itself.
• Dispose of packaging material immediately
according to locally applicable regulations.
2
Risk of electric shock
• Do not open the device or continue to operate
it if it becomes damaged.
• Do not use the product if the AC adapter,
adapter cable or power cable is damaged.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to
qualified experts.
4. Operation
Note – Mains voltage 100 – 240 V
The charger is suitable for a mains voltage of
100-240 V and can be used around the world.
Please note that a country-specific adapter may
be necessary.
Warning – Connecting terminal
devices
• Before connecting a terminal device, check
whether the power output of the charger can
supply sufficient power for the device.
• Ensure that the power of the connected
terminal device does not exceed 18 W.
• Please refer to the instructions in the operating
manual of your terminal device.
Note – QC 3.0, 2.0
• Plug & go: No manual setup necessary, just
connect and start:
Voltage and power are automatically
configured by QC 3.0, 2.0.
• For efficient and optimised charging, the QC
3.0, 2.0 function must be supported by your
terminal device.
• With the large quantity of QC-enabled terminal
devices with different firmware versions, it can
happen that the function is not fully supported.
Warning
• Only connect the product to a socket that has
been approved for the device. The socket must
be installed close to the product and easily
accessible.
• Disconnect the product from the network using
the power button – if this is not available,
unplug the power cord from the socket.
• When using a multi-socket power strip,
make sure that the sum power draw of all
the connected devices does not exceed its
maximum throughput rating.