Beem Cafe Joy V2 Bedienungsanleitung Seite 40

EN
Making espresso
Preheat the appliance as described in
the section Preheating the appliance
(page 34).
Check the water level in the water
tank (1) and add water, if necessary.
Remove the strainer holder as de-
scribed in the section Removing the
strainer holder (page 34).
Fill the strainer insert (13) with coffee
powder to the top and wipe off any ex-
cess coffee powder with the handle of
the measuring spoon (image C1, C2).
NOTE
inserted into the appliance.
Press down the coffee powder lightly
using the tamper (10) (image C3).
NOTE
Remove any surplus coffee powder
from the edge of the strainer holder
in order not to stain the seal of the
brewing unit (6).
Insert the strainer holder (12) into the
appliance as described in the sec-
tion Installing the strainer holder
(page 34).
Place a cup onto the drip tray (14) un-
der the strainer holder (12).
BEEM - Elements of Lifestyle
All manuals and user guides at all-guides.com
NOTE
If you wish to make two cups of
espresso at the same time, place
the cups next to each other on the
each of the openings on the under-
side of the strainer holder.
Turn the function selection switch (5)
to the position and allow the fresh-
ly brewed coffee to run into the cup.
Turn the function selection switch (5)
to the position after the desired
amount coffee has run into the cup.
Wait until the espresso stops dripping.
The pressure in the appliance will be
relieved and a little steam and water is
dispensed into the drip tray (14).
Press / (31) to switch off the ap-
pliance.
Clean the appliance as described
in the section Cleaning and care
(page 38).
Café Joy V2
35