Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Congratulations!
You have just purchased a Bora Portamate
Wood Rack. The Bora Portamate Wood Rack
is a compact storage system designed to help
you organize your workshop. It can be used for
a variety of materials including timber, moldings,
pipes, PVC and more. Applications include
garage walls, basements, sheds, and even
outdoor fences.
•
The Wood Rack provides 5 levels with a
capacity of 110 lb. (50 kg.) per level. It is
easy to install and easy to customize.
•
Due to product improvements, actual
product may vary slightly. Made in China.
1 Year warranty.
NOTICE: Assembly hardware located in
tubes at end of package
D
A
Figure 1
Figure 2
*PBR001 shown.
Other models
may vary slightly.
Figure 3
B
Assembly Instructions:
WARNING: Ensure your mounting location is capable of withstanding the
additional load. Never overload your rack. Note: Vertical bars can be used as
templates to mark your drilling locations before assembly.
1. Locate the bottom of the long vertical bar. It has a small screw hole 1/2
inch (13mm) from the end. Insert a screw A. Locate the bottom of an
orange horizontal bar B. It has a small notch as shown in the inset photo.
Slide the orange bar down the length of the vertical bar from the top until it
rests in position against the screw. Figure 1.
2. Insert a screw into the next hole up, then slide another orange bar into
position. Continue this process until all the bars are fitted, being careful that
all the notches face down. Repeat this process for the other side. Figure 2.
Note: Alternative rack positions can be achieved by drilling additional holes
where desired using a 5/32" (4 mm) drill bit.
3. Installing to drywall or other paneled wall sheeting: Locating a solid structural
support for your Bora Portamate Wood Rack is very important.
Ensure that you are securely contacting the center of the wall studs. Distance
between the vertical bars is optional. The recommended distance to support
the designed weight capacity is 4 – 6 ft. (120 - 180 cm). For longer material
or greater weight, multiple wood racks can be used.
Figure 3. The assembled Wood Rack is 1-5/8" (41mm) thick so a suitable
length of fastener is 3" (76mm) and 1/4" (6mm) diameter.
4. Position the Spacers C behind the mounting holes, and fasten to the
wall using the fasteners (not included) described in the recommended
installations.
PBR-001
Description
Part No.
A Screws (12)
S002
B Horizontal Bars (12) SH003
C Spacers (6)
S001
D Vertical Bars (2)
SV004
Description
A Screws (8)
B Horizontal Bars (8)
C Spacers (6)
D Vertical Bars (2)
4
PBR-002
Description
A Screws (10)
B Horizontal Bars (10) SH003
C Spacers (6)
D Vertical Bars (2)
PBR-004
Part No.
S002
SH003
S001
SV004
Part No.
S002
S001
SV004
Werbung
