ROWENTA AUTOMATIC Bedienungsanleitung Seite 51

If there is not enough water in the water tank when you start the program, the
come on to warn you. Add the appropriate amount of water to the container and cleaning will
continue automatically.If your machine is unplugged during cleaning or in the event of power
failure, you will have to restart the cleaning program right from the start. This is essential due
to water circuit rinsing reasons. In this case, you will need to use another cleaning tablet. Be
sure to complete the entire cleaning cycle to avoid any risk of irritation (seek medical advice if
cleaning solutions are accidently swallowed).
The cleaning cycle is a continuous cycle. Do not put your hands under the coffee outlets and
steam nozzle during the cycle.
Only use Krups (XS3000) cleaning tablets. We cannot be held responsible for any damage that
may result from the use of tablets from other brands. You can obtain cleaning tablets from
Rowenta Service Centres.
Make certain to protect your work surface during cleaning and scale removal cycles, especially if
it is made of marble, stone or wood.
SCALE REMOVAL PROGRAM - TOTAL DURATION : ABOUT 22 MINUTES
The quantity of scale deposited depends on the hardness of the water used. The appliance
will automatically warn you by the 'calc' light coming on when you need to proceed with
scale removal. This program is only accessible when the machine requests it.
Caution! To benefit from the guarantee conditions, it is essential to perform the appliance scale
removal cycle when informed to do so. Be sure to follow the procedure closely step by step.
You can continue to use the appliance when the light is on, but you are advised to perform the pro-
gram as soon as possible.
If your product is equipped with our Claris - Aqua Filter System F088 cartridge, please remove it
during the descaling operation.
Make certain to protect your work surface during cleaning and scale removal cycles, especially if
they are made of marble, stone or wood.
Press the 'Service' Remove and clean
the drip tray.
key to start up the
scale removal
program. The 'calc'
and lights will
flash.
Only use Krups F054 scale removal product. You can obtain scale remover from Rowenta Service
Centres. The manufacturer may not be held responsible for damage to the appliance through use
of other products.
Place a container
Empty the tank and
with a minimum
fill it with lukewarm
water capacity of
water up to the 'calc'
0.6 l under the coffee
marking.
outlets and under
the steam nozzle.
12
light will
GB
F054
Dissolve a sachet of
Krups scale remover
F054 (40 g).