Memory Function; Cleaning - eeese Adam Benutzerhandbuch

Auto Shut off with Water Tank Full Indicator
The unit will enter into standby mode when the water tank is full or when the water tank
is not installed properly. After emptying the tank, or installing the water tank properly, the
unit will go on to the previous mode.
Except for the power button, all other buttons are invalid.

Memory Function:

a. When unplugged directly or power is cut, then reconnect to the power supply, the
dehumidifier will run with the mode prior to the shutdown. The timer setting will
be kept.
b. Press the power button to switch off the dehumidifier, and then press the power
button to switch it back on. The dehumidifier will run with the mode prior to the
shutdown. The timer setting will be cancelled.
c. Switch off the dehumidifier and unplug the power cord, then reconnect the power
supply and switch on the dehumidifier. It will run in factory preset mode.
6.

Cleaning

When used regularly, the filter may become clogged with dust and particles. Therefore the
filter should be cleaned at least every two weeks. Follow these steps:
1
2
MV-2509-8-2020 . eeese-aircare.com © All rights reserved eeese air care aps
Switch the device off and remove the plug from the socket
before cleaning.
Clean the housing with soft, dry cloth. If the device is ex-
tremely dirty, use a mild cleaning agent. Wipe the dehumidi-
fier with a slightly damp cloth. Never spray the device with
water.
UK
79