General Safety Instructions; Risk Of Electric Shock; Before Installation - LIVARNO LUX HG06931A Montage-, Bedienungs- Und Sicherheitshinweise

General safety
instructions
Before using the product, please familiarise yourself
with all of the safety information and instructions
for use! When passing this product on to others,
please also include all the documents!
DANGER TO LIFE AND ACCI-
DENT HAZARD FOR TODDLERS
AND SMALL CHILDREN! Never
leave children unattended with the packaging
material. The packaging material represents a
danger of suffocation. Children frequently un-
derestimate the dangers. Please keep children
away from the product at all times.
This product may be used by children age
8 years and up, as well as by persons with re-
duced physical, sensory or mental capacities,
or lacking experience and / or knowledge, so
long as they are supervised or instructed in the
safe use of the product and understand the as-
sociated risks. Children should not be allowed to
play with the product. Cleaning and user main-
tenance should not be performed by children
without supervision.

Risk of electric shock

Always check product for damage before con-
necting it to power. Never use the product if it
shows any signs of damage.
Prior to installation, verify that the mains voltage
on site corresponds with the operating voltage
required for the product (230 V∼ 50 Hz). Other-
wise do not install the product.
CAUTION! DANGER OF BURN INJURIES!
To prevent burns, verify the product is switched
off and has cooled down for at least 15 min
before touching it. The product can become
very hot.
FIRE HAZARD! Fit the product so
that it is at least 0.5 m away from the
0.5 m
material to be illuminated. Excessive
heat can result in a fire.
14 GB/IE
CAUTION! RISK OF INJURY!
Broken lamp glass must be replaced
before any further use is made of
the product.
Only intended for installations out of normal
reach.
This product does not contain any parts that
can be serviced by the user. The LEDs cannot
be replaced by end user.
If the LEDs fail at the end of their lives, they must
be repaired by qualified electrician or the entire
product must be replaced.
The spotlight is only suited for use with the built-in
LED control gear.
The product continues to draw a small amount
of power even if the lamp is off as long as prod-
uct is connected to supply mains. To switch the
product off completely, the mains switch should
be switched off.
If the external flexible cable or cord of this lumi-
naire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a si-
milar qualified person in order to avoid a hazard.

Before installation

Important: The electrical connection must be
established by a qualified electrician or a person
trained to perform electrical installations. This person
must be familiar with the properties of the product
and the connection regulations.
Before installation ensure that the circuit, to which
the product will be connected, is not energised.
To do so, remove the fuse or switch off the circuit
breaker in the fuse box (0 position).
Use the voltage tester to verify the de-energised
status.
The included mounting material is suitable for
ordinary solid concrete or masonry construc-
tion. Check which mounting material is suitable
for your chosen mounting surface. If necessary,
seek expert advice.