Operation - Panasonic EY76A1 Bedienungsanleitung

WARNING
• Do not charge the battery pack in a
high-temperature location, such as next
to a fire or in direct sunlight. Otherwise,
the battery may overheat, catch fire, or
explode.
• After removing the battery pack from
the tool or the charger, always reattach
the pack cover. Otherwise, the battery
contacts could be shorted, leading to a
risk of fire.
• When the Battery Pack Has Deteriorat-
ed, Replace It with a New One. Contin-
ued use of a damaged battery pack
may result in heat generation, ignition
or battery rupture.
• To prevent leakage, overheating,
smoke generation, fire, and rupturing
from occurring, follow these instructions
when handling our rechargeable power
tools (tool main body/battery pack/
charger).
- Do not allow material cuttings or dust
to fall onto the battery pack.
- When storing, remove any material
cuttings and dust from the battery
pack, and place the battery pack
separately from metal objects
(screws, nails, etc.) when storing in
the tool case.
• Do not handle the rechargeable power
tools in the following way.
(There is a hazard of smoke genera-
tion, fire, and rupturing)
- Use or leave in places exposed to
rain or moisture
- Use submerging in water
II. ASSEMBLY
NOTE:
Disconnect battery pack from tool or
place the switch in the center position
(switch lock).
Attaching or Removing Bit
1. Hold the collar of quick connect chuck
and pull it out from the driver.
2. Insert the bit into the chuck. Release
the collar.
3. The collar will return to its original
position when it is released.
4. Pull the bit to make sure it does not
come out.
5. To remove the bit, pull out the collar in
the same way.
Use 6.35 mm hexagonal bits.
To ensure proper securement of the bit,
use only hexagonal bits with 9.5 mm
detent. [Fig.1]
Attaching or Removing Battery
Pack
1. To attach the battery pack: [Fig.2
Align the highlighted marker points and
attach battery pack.
Slide the battery pack until it locks into
position.
2. To remove the battery pack: [Fig.2
Push the button and slide the battery
pack forward.
III. OPERATION
WARNING!
• Do not inhale any smoke emitted from
the tool or battery pack as it may be
harmful.
[Main Body]
CAUTION
• When storing or carrying the tool, set
the Forward/Reverse lever to the
center position (switch lock).
NOTE:
Exercise caution to ensure no objects
come into contact with the tool's
trigger switch.
Switch and Forward/Reverse Lever
Operation [Fig.3]
Push the lever for forward or reverse
rotation. Check the direction of the lever
before using.
CAUTION:
When operating the tool by pulling the
trigger, there may be a momentary lag
before rotation starts. This does not
signal a malfunction.
- 9 -
EN
]
]