Xoro HRS 8600 CI Bedienungsanleitung Seite 84

Channel Search
DiSEqC mode
Here you can select the DiSEqC and tone-burst modes. With a single connection that is switched off.
Press the BLUE button to start scanning.
It now appears another query where you can specify additional search parameters. These are
individual with the options:
Polarization
Channel Type
Search Mode
Polarization
Here you can set the polarization. Please uses
the setting "Both". This then will both areas
(horizontal and
Otherwise, the search is only one of two orientations. You can not then find all the channels
Recommendation: Use the option both!
Channel Type
Here you can specify whether you want to receive from the search will only unencrypted channels or
all (including Pay TV) channels. If you want a subscription card in the 8600 HRS CI, then you should
select all the settings.
Recommendation: Use the all option!
Search method
In the search mode you can choose between AUTO, Blind and Manual.
•
For AUTO, the device has stored for each satellite, a transponder list and is searching at this
list.
•
Blind allows a search for all frequencies, regardless of the stored transponder list.
•
Manually examined solely by the listed transponders.
Recommendation: Use the AUTO!
Notes:
1. In general, the search with the default option is sufficient. However, there are always changes
to the transponder list. If any programs are not found, then go to the option blank.
2. With the 8600 HRS CI it is not possible to look at encrypted channels, you use for the "better"
table in the station list, select only free channels.
20
Both, horizontal, vertical
All, unscrambled
Auto, Blind, Manually
vertical) will be searched.
First steps
HRS 8600 CI