Corner Joints - Parkside PUD 30 A1 Bedienungsanleitung

Corner joints

♦ Attach the adjustable stop to the underside of the product and
screw in the locking screw loosely (see Fig. D).
♦ Place the drill bush onto a dowel on wooden workpiece .
Push the adjustable stop against wooden workpiece , tighten the
locking screw and remove the product (see Fig. E). This determines
the correct spacing for the drill holes in wooden workpiece .
♦ Place wooden workpiece parallel onto wooden workpiece
(see Fig. F).
♦ Push the product up to the stop on wooden workpiece (see Fig. F).
♦ Clamp both wooden workpieces firmly into place.
♦ Readjust the drilling depth to minus 6 mm of the thickness of
wooden workpiece plus 26 mm for the thickness of the product
itself.
♦ Slide the product with the matching guide groove to the drill bush
over the dowel until it stops (see Fig. F).
♦ Insert the drill into the drill bush and drill a hole (see Fig. F).
♦ Fill the drill holes with wood glue.
♦ Join the two wooden workpieces.
│ GB │ MT
■ 16
PUD 30 A1