Setup And Operating Procedures; Battery Loading; Clock And Date Adjustment - Gima KD-558 Bedienungsanleitung

SETUP AND OPERATING PROCEDURES

1. Battery loading

a. Open battery cover at the back of the monitor.
b. Load four "AA" size batteries. Please pay attention to polarity.
c. Close the battery cover.
When LCD shows battery symbol
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month or more to
avoid relevant damage of battery leakage.
Avoid the battery fluid to get in your eyes. If it should get in your eyes, im-
mediately rinse with plenty of clean water and contact a physician.
The negative terminal of the battery needs to be compressed into the bat-
tery compartment properly after horizontal compression of the negative
electrode. The battery is in contact with the spring.
Make sure the battery cover is intact and not damaged before installing
the battery.
The monitor, the batteries and the cuff, must be disposed of according to
local regulations at the end of their usage.

2. Clock and date adjustment

a. Once you install the battery or turn off the monitor, it will enter Clock
Mode, and LCD will display time and date by turns. See picture 2&2-1.
Picture 2
b. While the monitor is in Clock Mode, pressing both the "START" and "MEM"
button simultaneously, a beep is heard and the month will blink at first. See
picture 2-2. Press the button "START" repeatedly, the day, hour and minute
will blink in turn. While the number is blinking, press the button "MEM" to
increase the number. Keep on pressing the button "MEM", the number will
increase fast.
ENGLISH
Picture 2-1
, replace all batteries with new ones.
26
Picture 2-2