Initial Operation; Mounting Grip Rod; Installing The Grass Collection Box - Grizzly Tools BRM 46-125 BSA Originalbetriebsanleitung

lencers.
• If the fuel tank is to be drained, do this
outdoors.
• Handle your equipment with care. Keep
the tools sharp and clean to enable you
to work better and more safely. Follow
the maintenance directions.
• Do not attempt to repair the equipment
yourself unless you are trained to do so.
Any work not specified in these instruc-
tions is to be carried out only by cus-
tomer service centres authorised by us.
• Keep the equipment in a dry place and out
of reach of children. Machines are danger-
ous if used by inexperienced people.

Initial Operation

Caution! Risk of injury from
rotating blades. Carry out work
on the equipment only when the
blade is switched off and sta-
tionary.
Observe the Briggs & Stratton in-
struction manual supplied.
Before starting the device, you must
- mount the grip rod,
- fill in motor oil,
- fill in petrol,
- mount the grass catcher if necessary,
- set the cutting height if necessary.

Mounting grip rod

Make sure that the Bowden cable
( 5) is not crushed during the
assembly of the grip handle.
Mounting the lower bars:
1. Remove the two star grip screws
(20) from the machine housing
(16).
2. Attach the ends of the lower
handlebars (4) to the machine
housing (16).
3. Screw the two lower handlebars
(4) tight with the enclosed star
grip screws (20) on the right and
left of the mounting on the ma-
chine housing (16).
Mounting the upper grip:
4. Screw the upper grip (1) to the
right and left of the lower hand-
lebars (7) using the included
quick-release levers and nuts
(25).
5. Fold out the upper grip (1)
(small picture) and press the
locking lever (7) towards the
handlebar.
6. Fasten the Bowden cable (5)
using a cable clamp (6) to the
bottom handle (4).
Installing the Grass Collection
Box
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket:
1. Loosen the Phillips screw (24a)
on the carrying handle (24).
2. Place the carrying handle (24)
on the upper side of the grass
collector (22a) and screw it tight
with a Philips screw (24a) from
below.
3. Push basket rods (30) into bas-
ket net.
GB
89