Using Your Appliance; Using The Programmer; º How To Set The Time; º How To Adjust The Time - Brandt FP562WW Betriebsanleitung

99643801_A_ML.qxp 22/05/2007
EN

4 / USING YOUR APPLIANCE

INTRODUCTION TO THE PROGRAMMER
•
• How to set the time
- When supplied with electricity.
The display flashes at 12:00 (fig.1).
Set the time by pressing the + or - touch con-
trols (holding your finger on the touch control
allows you to scroll through numbers rapidly)
(fig.2).
Example: 12:30.
Press the " " touch control to validate.
The display stops flashing.
- To set the time on the clock.
The function selector switch must be in the
0 position (fig.1).
Press and hold the "
few seconds until the display is flashing
(fig.2), then release. Audible beeps indicate
that it is now possible to set the time.
Adjust the clock setting with the + and -
touch controls (fig.3).
Press the " " touch control to validate
(fig.4).
Warning
If the "
" touch control is not
pressed in order to validate, the time is
recorded automatically after a few seconds.
16:30 Page 60
" touch control for a
60
fig.1
fig.2
fig.1
fig.2
fig.3
fig.4