Service Information; Transport; Disposal And Recycling - Parkside PSKO 24 A1 Originalbetriebsanleitung

11.4 Cleaning the air filter (fig. 8, 9)
The air filter (4) prevents dust and dirt being sucked in. It is
essential to clean this air filter (4) after at least every 300
hours in service. A blocked air filter (4) significantly reduces the
compressor power.
Turn the air filter (4) counterclockwise to remove it. Open the
filter cover (4c) and remove it. You can now take out the filter
element (4b). Carefully tap out the filter element (4b), the filter
cover (4c) and the filter housing (4a). These components must
then be blown out with compressed air (approx. 3 bar) and
reassembled in reverse order.

11.5 Service information

With this product, it is necessary to note that the following
parts are subject to natural or usage-related wear, or that the
following parts are required as consumables.
Wearing parts*:air filter
* may not be included in the scope of supply!
11.6 Storage
m Attention!
Pull out the mains plug and ventilate the equipment
and all connected pneumatic tools. Store the
compressor in such a way that it cannot be used by
unauthorised persons.
m Attention!
Store the compressor only in a dry location which
is not accessible to unauthorised persons. Always
store upright, never tilted!
11.6.1 Releasing excess pressure
Release the excess pressure by switching off the compressor
and using the compressed air which is still left in the pressure
vessel (8), e. g. with a compressed air tool running in idle mode
or with a blow-out pistol.

12. Transport

Use the transport handle (1) to transport the device, and drive
the compressor with it.
When lifting the compressor, note its weight (see Technical
data).
Ensure that the load is well secured when transporting the
compressor in a motor vehicle.

13. Disposal and recycling

The device is supplied in packaging to avoid transport
damages. This packaging is raw material and can thus be used
again or can be reintegrated into the raw material cycle.
The device and its accessories are made of different materials,
such as metals and plastics. Take defective components to
special waste disposal sites. Check with your specialist dealer
or municipal administration!
The packaging is wholly
environmentally-friendly materials that can be
disposed of at a local recycling centre.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
electrical devices.
Old devices must not be disposed of with household
waste!
This symbol indicates that this product must not be
disposed of together with domestic waste in compliance
with the Directive (2012/19/EU) pertaining to waste
electrical and electronic equipment (WEEE). This
product must be handed over at the intended collection point.
This can be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised collection
point for the recycling of old electrical and electronic devices.
Improper handling of waste equipment may have negative
consequences for the environment and human health due to
potentially hazardous substances that are often contained in
electrical and electronic equipment. By properly disposing of
this product, you are also contributing to the effective use of
natural resources. You can obtain information on collection
points for waste equipment from your municipal administration,
public waste disposal authority, an authorised body for the
disposal of waste electrical and electronic equipment or your
waste disposal company.
composed of
GB 39