Use As A Floor-Mounted Appliance; Assembling The Paint Scraper; Use Of Adapter Nozzles; Restrictor - Parkside PHLGD 2000 A1 Originalbetriebsanleitung

Use as a floor-mounted
appliance
You can use the device as a floor-mounted
appliance. For this purpose, place the de-
vice on the two bases (14).
Ensure stability and safety and a heat-
resistant surface.
The position as a floor-mounted appli-
ance is also ideally suited to allowing
the device to cool down after use.
Assembling the paint
scraper
1. Unscrew the top nut (16) from the
handle (8).
2. Place the metal triangle (7) onto the
lower nut.
3. Screw the top nut back on in order to
tighten the metal triangle.

Use of adapter nozzles

Before exchanging adapter
nozzles, the adapter nozzle
(10/11/12/13) and blow-off pipe
(1) must be sufficiently cooled down
to avoid burns.
Various uses are possible. Always
comply with the safety instructions
and always handle the device with
care and caution.

Restrictor

Place the restrictor (13) on the blow-off
pipe (1).
Use the restrictor (13) to obtain selective
heat.
When using the restrictor (13),
pay particular attention to the heat
development at the cutting point. If
in doubt, do not stay in the same
place for too long in order to avoid
overheating the workpiece.

Surface nozzle

Place the surface nozzle (11) on the blow-
off pipe (1).
Use the surface nozzle (11) to obtain heat
over a large surface.
When using the surface nozzle
(11), pay particular attention to the
heat development in adjacent loca-
tions of the cutting point. So that in
cases of doubt, no adjacent compo-
nent is overheated.

Spatula nozzle

Place the spatula nozzle (12) on the blow-
off pipe (1).
The spatula form of the nozzle serves the
purpose of the targeted hot air supply to
paint and lacquer surfaces. The paints and
lacquers can be removed with the paint
scraper (9). The spatula (12) itself is not
suitable for removing paint.

Grill lighter nozzle

Place the grill lighter nozzle (10) on the
blow-off pipe (1).
Change the device with the step switch
5) to level "II". Place the grill lighter
(
nozzle (10) below the charcoal. Make sure
that the openings of the grill lighter noz-
zle (10) are not covered by charcoal as
this creates heat accumulation in the unit,
which is a potential fire hazard In just a
few minutes the charcoal is ignited.
GB MT
39