Draining Water - Klarstein MAX BREEZE SMART 15K Bedienungsanleitung

EN
46

Draining water

When you use the appliance in cooling or dehumidifying mode, moisture extracted from
the ambient air is collected in the water tank inside the appliance. When the water tank
is full, the compressor and the motor of the appliance are automatically switched off. At
the same time, the "Water tank full" indicator lights up. An alarm tone also sounds. To
empty the water tank, follow the instructions below:
1. Switch off the appliance and do not move it while the water tank is full.
2. Place a container (for example a water bowl) under the drain hole.
3. Remove the drain knob and rubber plug from the drain hole and allow the water to
drain off.
4. Replace the rubber plug and drain knob when the water bowl is almost full and
empty it.
5. Repeat steps 2-4 until the water tank is empty.
6. Then replace the rubber plug and drain knob and tighten the drain knob properly.
7. When you switch the appliance on again, the display "Water tank full" or
"Compressor running" should stop flashing.
If you do not want to empty the water tank so often, proceed as follows:
• Remove the rubber plug and drain knob from the appliance and keep them for
future use.
Drain hole
Rubber plug
Drain knob