Control Panel - Husqvarna AUTOMOWER 405X Bedienungsanweisung

10. Attach the guide wire to the ground with stakes or
bury the guide wire in the ground. Refer to
the wire into position with stakes on page 84 or
To bury the boundary wire or the guide wire on
page 84 .
11. Connect the charging station to the power outlet.
33.6 To put the wire into position with
stakes
CAUTION:
Make sure that the stakes
hold the boundary wire and the guide wire
against the ground.
CAUTION:
Cutting the grass too low
right after installation can damage the wire
insulation. Damage to the insulation may not
cause disruptions until several weeks or
months later.
1. Put the boundary wire and the guide wire on the
ground.
2. Put the stakes at a maximum of 75 cm / 30 in.
distance from each other.
3. Attach the stakes to the ground with a hammer or
a plastic mallet.
Note:
The wire is overgrown with grass and not visible
after a few weeks.
33.7 To bury the boundary wire or the
guide wire
• Cut a groove in the ground with an edge cutter or a
straight shovel.
• Put the boundary wire or the guide wire 1-20 cm /
0.4-8 in. into the ground.
84 - Installation
33.8 To do a visual check of the
charging station
1. Make sure that the indicator LED lamp on the
charging station has a green light.
2. If the indicator LED lamp does not have a green
light, do a check of the installation. Refer to
Indicator lamp in the charging station on page 90
and To install the charging station on page 82 .
33.9 To do the basic settings
Before the product starts to operate for the first time, you
must do the basic settings.
To put
1. Put the product in the charging station.
2. Switch on the product.
3. Push the arrow buttons and the OK button. Select
language, country, date, time and set a PIN code.
Note:
For some models, a factory PIN code is
necessary before you select a personal PIN code.
It is not possible to use 0000 as PIN code.
4. Push the Start button and close the hatch to initiate
a calibration process of the product.
Note:
Make a note of the PIN code. Refer to
Introduction on page 73 .

33.10 Control panel

All commands and settings for the product are made via
the control panel. All functions are accessed via a
number of menus.
The control panel consists of a display and a keypad. All
information is shown on the display and all input is done
using the buttons.
Note:
The display texts are shown in English in the
manual, but you will see the texts on the product display
in the chosen language.
33.11 Display
When the STOP button has been pushed and the hatch
is opened, the following information is displayed:
• Operating information, e.g.
PARKED or SCHEDULE . READY is displayed if
READY , MOWING ,
1508 - 004 - 22.12.2020