Scope Of Use - Kemper Filter Modul F Montage- Und Betriebsanleitung

Materials
Intermediate flange
Filter casing
Segment-filter sleeve stainless steel / POM
Back-flush valve
Overflow cap
Fixing screws
Closing plug
Outflow funnel
Packing
1.2

Scope of use

The back-flush filter Module F is tested
according to DIN EN 13443-1 and it has been
designed for use as a filter valve for drinking
water installations according to DIN 1988.
The Module F filter is mounted into a piping
system together with the KEMPER Basic
Module Figure 700 0G. In case of need it
can be optionally added to the Module DMF
pressure reducing valve-filter combination,
so that instead of the overflow cap mounted
at works the pressure reducing valve module
Figure 710 0G is added.
22 / 36 – K410071200001-00 / 05.2021 – © www.kemper-olpe.de
gunmetal
PA
gunmetal
PPA
stainless steel
gunmetal
POM
NBR / EPDM
Due to hygiene and functional reasons,
the fillter shall not be used for well water
systems, as this might be classified as non
potable water. There is a risk of microbio-
logical contamination and clogging of the
filter in such a system. Industrial and process
water can be filtered with the DMF (Filter/
PRV combination). The used water must be
treated and free from bigger particles. Shor-
ter periods for processing a backwash are
recommended to avoid clogging.