Tripp Lite B127M-101-H Bedienungsanleitung Seite 14

Standard Extender Kit Installation
7. Connect the external power supply to the transmitter unit.
Plug the unit into an available wall outlet or a Tripp Lite surge
protector, power distribution unit (PDU) or uninterruptible
power supply (UPS). The POWER (green) LED on the local
splitter unit will illuminate to indicate the unit is receiving
power from the external power supply. The POWER (green)
LED on the remote receiver unit will illuminate to indicate the
unit is receiving power from the local transmitter unit through
PoC technology.
8. Turn on the power to the HDMI source. The OUTPUT (orange)
LED on the local transmitter unit will illuminate to indicate a
signal is being received from the source.
9.
The (orange) RJ45 LED will illuminate on both the local
transmitter and remote receiver units to indicate a signal is
being received from the source to display. The screen should
now display on the connected monitor(s).
14