Cameo ROOT PAR BATTERY Bedienungsanleitung Seite 18

same model and software version, which could otherwise only be achieved with a suitable DMX
controller and complex programming.
--------Menu-------
----Slave Group----
DMX Address
DMX Mode Stand Alone
1 - 15
DMX Delay Slave
Stand Alone Settings
Slave
Settings
System Info
Assign the spotlight to one of 15 groups as you like. Several spotlights can also be assigned to
one group. The group number is also the factor by which the set delay time on the master unit is
multiplied (see setup example).
Slave Group 0
No delay
Master unit
Mode
Auto program 1
Slave
Delay 0.5 s
SYSTEM SETTINGS (Settings)
Starting from the main display, press MENU to go to the main menu. Using the  and  buttons,
now select the Settings menu option and press ENTER to confirm your selection.
--------Menu-------
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the submenu options (see table, use  and  to
select, press ENTER to confirm, use  and  to change the value or status, press ENTER to
confirm).
Settings
Disp Rev = Rotates display
18
Mode
Slave
Gr 1 2.0s
Main display
with group number
and delay time in the
master unit
Slave Group 1 Slave Group 2
0.5s delay 1s delay
Mode Mode
Slave Slave
Gr 1 0.5s Gr 2
No
Yes
Slave Group 3 Slave Group 4
1.5s delay 2s delay
Mode
Slave
0.5s Gr 3 0.5s Gr 4
Mode
Slave
Gr 3 0.5s
Mode
Slave
Gr 3 0.5s
Display does not rotate
Display rotates 180° (e.g., for overhead
installation)
Slave Group 5
2.5s delay
Mode Mode
Slave Slave
0.5s Gr 5 0.5s