Jinbei DMII-4 Anleitung Seite 26

• Insert the light shaper with the three bayonet pins [c] into the cor-
responding recesses on the flash unit and lock it by briefly turning
it to the right until it audibly clicks into place .
• To remove the light shaper, pull the bayonet release button [b] to
the rear, turn the light shaper to the left and pull it off to the front .
• Connect the unit to the mains using the mains cable supplied .
• To switch on, press the on/off switch [19] on the back of the unit, the
LC display switches on .
• Select the various unit functions (see page 28ff . ) .
• To switch off, press the on/off switch [19] on the back of the unit, the
LC display switches off .
• Please allow the unit to cool down before packing it for transport
or storage . If necessary, remove the light shaper or umbrella, dis-
connect the flash from the mains and replace the protective cap
on the flash tube.
2) Notes on synchronisation
Simultaneous triggering of camera and flash (synchronisation) is
possible via:
• A sync cable (3 . 5 mm mini-jack), for direct connection between
camera and flash or for connecting flash triggers from other ma-
nufacturers to the sync socket [14] .
• The photocell / infrared sensor [11] built into the flash. For this you
need an infrared remote trigger for your camera or you trigger the
flash as a slave flash via the light pulse of another flash.
• The radio receiver (2.4 GHz) built into the flash. For this you need
one of the compatible Jinbei radio remote controls TR-Q7, TR-Q6,
TR-V6, TRS-V for your camera .
Operation
26