Operation - Worx WU736 Bedienungsanleitung

The coded projection (12) on the protection guard (10) ensures that
only a guard that fits the machine type can be mounted.
Loosen the clamping screw (11), if necessary.
Place the protection guard (10) with coded projection (12) into the
coded groove on the spindle collar of the machine head and rotate to
the required position (working position).
The closed side of the protection guard (10) must always point
to the operator.
Tighten clamping screw (11).

Operation

STARTING OPERATION
Your switch is locked off to prevent accidental starting. To switch on
your tool, push the safety switch lever (B) forward and depress on/off
switch (A) fully. Now your tool is switch on. To switch off your tool,
just release the On/Off switch.
If you wish to use the tool continuously, push the safety switch lever
(B) forward and depress on/off switch (A) fully, then push the safety
switch lever (B) forward again and release the On/Off switch. Now
your switch has been locked on for continuously use. To switch off
your tool, simply depress On/Off switch fully, the safety On/Off
switch will automatically release. (See D)
SOFT START MOTOR
Internal electronic components allow the motor speed to increase
slowly, which reduces the"twisting"effect on your wrists due to the
high power motor.
All manuals and user guides at all-guides.com
•
•
•
•
1
2
3
11
OPERATING INSTRUCTIONS
Clamp the workpiece if it does not remain stationary due to its own
weight.
Do not strain the machine so heavily that it comes to a standstill.
Grinding and cutting discs become very hot while working; do not
touch until they have cooled.
Pull the plug from the socket-outlet when not using the
machine. With the plug inserted and mains voltage existing, the
power tool still has low power consumption even when it switched
off.
HAND GRIP AREAS
Always hold your angle grinder firmly with both hands when
operating (See E).
ROUGH GRINDING
The best roughing results are achieved when setting the machine
at an angle of 30° to 40°. Move the machine back and forth with
moderate pressure. In this manner, the workpiece will not become
too hot, does not discolour and no grooves are formed.
Warning! Never use a cutting disc for roughing.
CUTTING
When cutting, do not press, tilt or oscillate the machine. Work with
moderate feed, adapted to the material being cut.
Do not reduce the speed of running down cutting discs by applying
sideward pressure.
The direction in which the cutting is performed is important.
The machine must always work in an up-grinding motion. Therefore,
never move the machine in the other direction! Otherwise, the