Cleaning Side Brushes - Shark AI ROBOT RV2001EU Gebrauchsanweisung

MAINTENANCE
SHARK ANTI HAIR WRAP TECHNOLOGY®
The Anti Hair Wrap Brush-roll actively removes hair wrap while your robot cleans.
If some debris remains wrapped around the brush-roll, continue to run the robot
to give the brush-roll time to clean itself. If some hair wrap or debris remains after
continued cleaning, carefully remove it from the brush-roll.
To access the brush-roll, push up on the tabs on the
brush-roll door, then lift off the door.
NOTE: Replace brush-roll every 6 to 12 months, or when visibly worn. See sharkclean.eu for replacement parts.
s h a r kc l e a n . e u
Lift out the brush-roll and remove any debris.
Reinstall the brush-roll, inserting the flat end first.
Close the brush-roll access door and press down
until both sides click into place.
MAINTENANCE
CLEANING SENSORS AND CHARGING CONTACTS
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED. With a dry cloth, gently dust off the sensors
and contacts located on the bottom of the robot and on the dock.
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.

CLEANING SIDE BRUSHES

CLEAN SIDE BRUSHES AS NEEDED.
NOTE: Remove and replace any side brushes that are bent or damaged. To remove a brush, lift it off its peg.
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a dry cloth. To reinstall,
snap the brushes over the pegs. Spin the brushes
manually to make sure they are installed correctly.
s h a r kc l e a n . e u