Food Processing Attachments; Operation; Using The Cutting Blades - Kompernass KM 250 D1 Bedienungsanleitung

Food processing attachments

1) Select the desired attachment:
–
the slicer attachment w
–
or the grater attachment q.
2) If a different disk is still installed: Ideally, turn
the disc adapter 0 upside down. Press the
long metal tab of the disc inwards with your
thumb so that this side of the disc is released
from the disc adapter 0. You can now remove
the disc.
3) Insert the new disc with the short metal tab first
into the disc adapter 0:
4) Then carefully push the side with the long metal
tab into the disc adapter 0. The best way to
do this is to press with both thumbs on the
outer edges of the attachment until it clicks
completely into place in the disc adapter 0.
5) Place the disc adapter 0 with the attachment
fitted onto the drive shaft 6. The flattened side
of the drive shaft 6 must correctly fit into the
take up of the disc adapter 0. Otherwise the
disc adapter 0 cannot be properly attached.
■ 6 │ GB │ IE │ NI │ CY
6) Place the lid 3 onto the bowl 5 so that the
arrow ▼ on the lid 3 coincides with the
arrow and the opened lock symbol
on the bowl 5.
7) Turn the lid 3 until the arrow ▼ on the lid 3
points to the arrow
on the bowl 5.
symbol
8) Place the pusher 1 into the feed tube 2.
9) Insert the plug into a mains power socket.

Operation

Using the cutting blades

The cutting blades 4 can be used to chop foods
such as onions or meat.
NOTE
► Do not attempt to mix liquids with the cutting
blades 4. These will overflow or spray out.
1) Fit the cutting blades 4 as described in the
chapter "Assembling the appliance".
2) Cut the ingredients into pieces of
approximately 2 – 3 cm.
3) Pour the ingredients in. Do not exceed the
quantities specified in the following table.
INGREDIENT MAX. AMOUNT
Bread
Cheese
Meat
Herbs
Garlic
Onions
Ice cubes
and the closed lock
SPEED
max. 80 g
max. 150 g
max. 300 g
max. 30 g
80 – 200 g
max. 300 g
max. 140 g
KM 250 D1
1
1
1
1
P
P
P