Sonnenkönig SLIM M 1000 Bedienungsanleitung Seite 52

Leg mounting of the convector
1. Take 2 legs out of a package box.
2. Turn over the units so that its lower part was
at the top.
3. Attach legs to the lower part of the unit from
EN
the left and right sides so that the mounting holes
coincide with holes on the unit's case.
4. Fasten mounting screws in the present holes, exer-
ting enough force. Check security of mounting.
5. Turn over the unit to the right position and place
it on smooth, horizontal surface strictly in a verti-
cal position. The unit is ready to use!
Connection to electric mains
1. The convector is designed to be connected to 230 V single-phase voltage mains with a
grounding circuit.
2. Prior to connection comply parameters, indicated on the identification plate with
technical data of the unit.
3. It is necessary to follow active electrical safety precautions, connecting the convector
to electric mains.
4. An electric outlet must be properly grouded. The outlet must be designed for rated current
not less than 10 A. Electric outlet and plug must always stay dry to prevent current leakage.
Regularly check if the electric plug is tightly connected to the outlet. It must be done in the
following order:connect an electric plug into an outlet, after half hour operation turn off the
convector and disconnect the plug from the outlet, check if the plug is heated by your hand. If
the plug heated over 50° C then replace the outlet by a new one to prevent damages, incidents,
fire as a result of bad elteric contact. A specialist must do the job.
IMPORTANT!
The electric outlet must be rated for not less than 10 A, electric cable with a strand with cross
section not less than 3x1.5mm² (for copper).
5 Control of the convector
The models SLIM 1000 M, SLIM 1500 M and SLIM 2000 M are equipped with a mechanical thermostat.
SLIM M 1000 / SLIM M 1500 / SLIM M 2000 Control panel
52
Fig. 7
(Fig. 8)