Information On The Electrical Connections; Laying Cables - Waeco PerfectView CAM60ADR Einbau- Und Bedienungsanleitung

Information on the electrical connections

The camera transmits the image as if you are looking in the rear mirror.
The camera consists of the following main elements:
No. in
Description
fig. 7, page 5
1 6-pin connection cable
2 Infrared LEDs
3 Microphone
7 Information on the
electrical connections
7.1

Laying cables

A
NOTICE! Risk of damage!
 To prevent damage, when drilling ensure that there is suffi-
cient space on the other side for the drill head to come out.
 Cables and connections which are not properly installed will
cause malfunctions or damage to components. Correct instal-
lation of cables and connections is the basic prerequisite for
lasting and trouble-free operation of the retrofitted compo-
nents.
 The cables may not be exposed for long periods to solvents
such as benzine, as the solvents can damage the cable.
Please observe the following instructions:
 As far as possible, use original openings or alternative openings for the
connecting cable duct, e.g. the paneling edges, ventilation grilles or blank
panels. If no openings are available, you must drill holes for the cables.
Check beforehand that there is sufficient room for the drill head to come
out on the other side.
 Wherever possible lay cables inside the vehicle, as they are better
protected inside than outside the vehicle.
If you do need to lay a cable outside the vehicle, ensure that it is well
secured (use additional cable ties, insulating tape, etc.).
28
PerfectView CAM60ADR
EN