Theft Protection; Device Code; Entering The Code; Adjusting The Code - Blaupunkt new jersey mp68 Bedienungs- Und Einbauanleitung

Theft protection

Device code

You can protect this device against theft with an
individual, four-digit code number. If the code
query is activated, the code number must be en-
tered after every interruption of the power sup-
ply from the vehicle battery. Without this code
number, the device is useless to a thief.
You can activate and deactivate the code query:
If you set the code number to "0000", the code
query is automatically deactivated. As soon as
you enter a different code number than "0000",
the code query is automatically activated (see
the section "Adjusting the code").
The code number is factory set to "0000", so that
the code query is deactivated. It is recommend-
ed to set an individual code number and thereby
activate the code query. Your device is then use-
less to a thief and protected against abuse.
Note:
Record your individual code number and
store it in a safe place. For example, enter
the individual code number in the device
card and store the device card separate from
the device outside of the vehicle!

Entering the code

If a different code number than "0000" is set
and the device has been disconnected from the
vehicle's electrical system (e.g. removal of the
battery in case of repairs), the display shows
"PLEASE ENTER CODE" and "_ _ _ _" after switch-
on, and you can enter the code.
Notes:
•
You have 6 attempts to enter the correct
code before the device is blocked and can
only be enabled with the master code.
•
You can switch off the device again
without having entered the code.
u
Enter the code by pressing the correspond-
ing buttons of the A keys.
Press the OK button : to confi rm the code
u
entered.
After entering the correct code, "CODE OK!!"
briefl y appears on the display and the device
starts with the last used audio source. After en-
tering an incorrect code, "INCORRECT CODE!!"
PLEASE TRY AGAIN!!" briefl y appears on the
display. You can repeat the code entry fi ve more
times.
After the fourth incorrect entry, the display shows
"2 TRIALS LEFT!! RADIO WILL BE BLOCKED
AFTER THAT! PRESS OK".
Press the OK button : to reach the code
u
entry again.
After the fi fth incorrect entry, the display shows
"1 TRIAL LEFT!! RADIO WILL BE BLOCKED AFTER
THAT! PRESS OK".
u Press the OK button : to reach the code
entry again.
After the sixth incorrect entry, the display shows
"THE RADIO IS BLOCKED!! PLEASE CONTACT
THE SERVICE CENTER". Contact your Blaupunkt
specialised dealer or the Blaupunkt customer
service.

Adjusting the code

Adjust an individual code number to automati-
cally activate the code query, or set the code
number to "0000" to deactivate the code query.
The code number is factory set to "0000", so that
the code query is deactivated.
Theft protection
75