Geberit ACO 102 Betriebsanleitung Seite 20

EN
Function
5
1
2
3
4
6
1 Start button
2 Red LED
3 Green LED
4 Charge level indicator
5 Unlocking button
6 Swivelling pressing head
0
Automatic pressing function
The Geberit pressing tool functions electrohydraulically. An automatic pressing function
makes sure that the press connection is completely finished. The automatic pressing
function does not switch on until approx. one second later. After the automatic pressing
function has switched on, the green LED [3] goes out and the pressing sequence proceeds
automatically. The pressing sequence can only be interrupted by pressing and holding the
unlocking button [5]. When the pressing sequence is finished, the motor automatically
switches off and the green LED [3] lights up again.
If the start button [1] is released before the automatic pressing function switches on, the
piston in the pressing tool will move back to its starting position. The pressing sequence is
not finished and must be restarted.
Unlocking button [5]
The pressing sequence can be interrupted by pressing and holding the unlocking button [5].
The piston in the pressing tool moves back to its starting position. Pressing the start button
[1] again restarts the pressing sequence.
LED display [2] [3]
The two LEDs [2] [3] show the operating states of the pressing tool. The pressing tool is ready
for operation when the green LED [3] is lit. The red LED [2] or the flashing green LED [3]
indicate malfunctions.
Charge level indicator [4]
The four green LEDs [4] show the charge level of the rechargeable battery. The number of lit
LEDs indicates the charge level. The rechargeable battery is empty when the green LED [3]
flashes.
Swivelling pressing head [6]
The pressing tool has a swivelling pressing head that can swivel 180°. This can only be
swivelled before pressing. To swivel the pressing head, hold the grip area of the pressing tool
and swivel the front part of the pressing cylinder.
Standby mode
If the Geberit pressing tool is not used for 30 minutes, it switches to standby mode. No LED is
lit. To start the pressing tool, briefly press the start button [1].
B1024-003 © 06-2015
20
965.804.00.0 (02)