Cleaning And Maintenance - BOMANN KSG 239.1 Bedienungsanleitung, Garantie

Switching off
To switch off the appliance turn the temperature con-
trol to the off state.
If the appliance is out of use for long periods:
• Remove the appliance content.
• Disconnect the appliance from the power supply.
The control lamp disappears.
• Defrost (model dependent) and clean the device
thoroughly (see "Cleaning and Maintenance").
• Leave open the appliance door to avoid formation
of mold and unpleased odor.
Tips for Energy saving
• Disconnect the appliance from the power supply if
it isn't in use.
• Do not install the appliance near stoves, heaters,
or other heat sources. In case of higher ambient
temperatures, the compressor will run more fre-
quently and longer.
• Ensure enough ventilation at the bottom and rear
side. Never block ventilation openings.
• Place all shelves, racks or drawers (depending on
the model) in their original position.
• Adjust the temperature not colder than necessary.
• Allow warm food to cool before placing it in the
appliance.
• Open the unit door only as necessary.
• Defrost the unit regularly (model dependent).
• Switch on the lighting only if necessary.
• The seal of the appliance door must be complete-
ly intact, so that the door closes properly.

Cleaning and Maintenance

WARNING:
• Always disconnect the appliance from the power
supply before cleaning and user maintenance.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage
the plastic parts.
• The unit must be dry before restarting operation.
CAUTION:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
Cleaning the appliance including interior
• Clean the appliance interior, the exterior surfaces,
the accessories, and the door seal regularly with
warm water and mild detergent.
• Remove the appliance content and storage it at a
cool location.
• Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
• After everything was thoroughly dried, you can
restart the operation.
Depending on model:
•
the dust that has accumulated on the appliance
back and condenser (metal grille). To do this, use
a soft brush or a vacuum cleaner.
Defrosting
CAUTION:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
The appliance has an automatic defrosting system.
During defrosting water drops drains off at the back
of the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate. Make
18
Wipe at least once a year