Technical Data; Installation Instructions - Avintage AVI24S2X Gebrauchsanweisung

2. TECHNICAL DATA

Below is an example of the nameplate:
The nameplate attached to the inside or rear of the appliance (depending on the model) includes the
entire information specific to your appliance.
We recommend that you make a note of its serial number in this booklet prior to installation, so that you
can refer to it later (technical work, request for assistance, etc.).
Once the appliance is installed and loaded, access to it is not so easy.
CAUTION: no assistance can be provided without this information.

3. INSTALLATION INSTRUCTIONS

Before using this appliance
• Remove the exterior and interior packing.
• Check to be sure the following parts are included: AVI24S2X, 3 wire shelves and 1 instruction manual.
• Before connecting the appliance to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• When disposing your appliance, please choose an authorized disposal site.
• Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded.
• Keep the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold or hot ambient temperatures may also cause the appliances not to perform properly.
• Adequate ventilation is required, do not block the front air outlet.
• Not designed for placement in adage or basement.
41