Shipping And Storage; Care; Plastic Parts - Vermeiren V100 XL Gebrauchsanweisung

Footrests
ƒ
Brake lever
ƒ
Wheel axles
ƒ
Every 6 months or for every new user
•
General review
ƒ
Disinfection
ƒ
Frontwheels, possibly clean bearings
ƒ
For your convenience, on the back of this manual is a maintenance plan.
Repairing and assembling of spare parts for your wheelchair may only be performed by the
specialist dealer.
Only authorized Vermeiren spare parts may be installed.
4.2

Shipping and storage

The shipping and storage of the wheelchair shall be according following instructions:
Store in a dry place (between +5 ° C and +41 ° C).
•
The relative humidity of the air should be between 30% and 70%.
•
Provide sufficient covering or packaging to protect the wheelchair from rust and
•
foreign bodies. (e.g. salt water, sea air, sand, dust).
Store all removed parts together in one place (or mark them if necessary) to avoid
•
mixing up with other products when re-assembling.
Components must be stored without being subjected to strains (Do not put too heavy
•
parts on the wheelchair, not clamping between something, ...).
4.3

Care

4.3.1 Seat and back cushions
The cleaning of the seat and back cushions shall be according:
Clean seat and back cushions with a cloth moistened with hot water. Be
ƒ
aware that you do not soak the seat and back cushions.
Use a mild commercial detergent for removing stubborn dirt.
ƒ
Stains can be removed by using a sponge or a soft brush.
ƒ
Do not use strong cleaning liquids like solvents, nor use hard brushes.
ƒ
Never clean with steam and/or pressure washers.
ƒ

4.3.2 Plastic parts

Clean plastic parts of your wheelchair with commercial plastic cleaners. Only use a soft
brush or soft sponge.
Examples of plastic parts are the armrests, footrests, handles, tyres and ... .
4.3.3 Coating
The high quality of the surface layer guarantees optimal protection against corrosion. If the
outer coat is damaged by scratching or in some other way, get your specialist dealer to
repair the affected surface.
When cleaning, only use warm water and normal household detergents and soft brushes
and cloths. Ensure that no wetness gets into the tubes.
Initially the zinc parts only require rubbing with a dry cloth. Stubborn dirt can best be
removed by using a suitable commercial zinc polish.
ƒ‰‡
V100 XL
2012-02