Cleaning And Maintenance - BRAYER BR1015 Bedienungsanleitung

kettle with water and switch it on, the electric kettle will
operate in normal mode.
MAKING TEA
• Take the handle (10), pull it upwards and remove the
lid (9).
• Put the necessary amount of tea leaves in the tea
infuser (7) and install the tea infuser (7) in the inner
surface of the lid (9), make sure that the tea infuser (7)
is fixed properly.
• Fill the kettle with water not below the mark «MIN» and
not above the maximal mark «MAX» on the scale (6).
• Press the button (2) «40-70-85-100°С» to select the
necessary water heating temperature for a particular
kind of tea (see the chapter «HEATING WATER UP TO
THE REQUIRED TEMPERATURE»).
• Switch the kettle on by pressing the «ON/OFF» button
(1).
• After the use wait until the kettle cools down, remove
the lid (9), remove the tea infuser (7) and wash the
tea infuser (7) under running water. Over time, a
dark coating may form on the tea infuser (7), you can
remove it with baking soda. Moisten a cloth with water,
sprinkle a small amount of baking soda on it and wipe
the tea infuser (7) from the outside and inside, after
removing the coating rinse the tea infuser (7) and dry.

CLEANING AND MAINTENANCE

• Before cleaning disconnect the kettle from the mains,
pour out water and let the kettle cool down.
• Wipe the base (4) and the outer surface of the flask (5)
with a slightly damp cloth, and then wipe the base (4)
and the flask (5) dry. Use soft detergents to remove dirt;
do not use metal sponges and abrasive detergents and
solvents.
• Do not immerse the electric kettle into water or any other
liquids, do not wash it in the dishwasher.
DESCALING
• Scale, appearing inside the flask (5), influences the
water taste and disturbs the heat exchange between
water and the heating element and also creates a risk of
failure of the heating element, the burnout of the heating
element because of large amount of scale in the flask (5)
is not covered by warranty.
• To remove scale, you can use special scale-removing
agents, as well as household ones, for example, vinegar
or citric acid.
• To remove scale, fill the flask (5) with water one-third full
and boil it. Open the lid and add table vinegar (6-9%) to
the «MAX» mark, leave the liquid in the kettle for several
hours. After the scale dissolves, pour out the liquid and
rinse the flask (5) several times. To oust the smell of
vinegar, boil water several times.
• Dissolve 25 g of citric acid in 500 ml of hot water.
• Fill the kettle with the prepared solution and leave for
15-30 minutes.
• Pour out the liquid and rinse the flask (5) several times,
boil water several times.
EN 9