Harman AKG IVM 4 Bedienungsanleitung Seite 27

Thank you for purchasing an AKG product. This Manual contains important in-
structions for setting up and operating your equipment. Please take a few minutes
to read the instructions below carefully before operating the equipment. Please
keep the Manual for future reference. Have fun and impress your audience!
• 1 SST 4 stereo transmitter
• 1 SPR 4 bodypack stereo receiver
• 1 pair of IP 2 earbuds with 3 pairs of ear molds
• 1 rod antenna
• 1 rack mounting kit
• 1 power supply
• 2 AA size dry batteries
• 1 12-pc. color coding kit
• Check that the packaging contains all of the items listed above. Should any of
these items be missing, please contact your AKG dealer.
• SPC 4 wideband antenna combiner
• SRA 2 W passive wideband directional antenna
• RA 4000 W passive wideband omnidirectional antenna
• HPA 4000 headphone amplifier
• PSU 4000 central power supply
• HUB 4000 Q network interface
• MK PS antenna cables
• Front panel mounting kit for supplied antenna
• BP 4000 3-V rechargeable battery pack
• CU 4000 charger for 2 receivers or BP 4000 battery packs
The SST 4 is a stationary stereo transmitter designed to transmit a mono, stereo,
or dual-channel signal to the SPR 4 bodypack stereo receiver. It allows you to se-
lect one of 1200 frequencies within a 30-MHz band. In addition, it provides an in-
tegrated compressor, limiter, highpass filter, and a dedicated binaural room
simulator. You can use the transmitter as a standalone unit or install it in a 19" rack
using the supplied rack mounting kit.
1 2
1 ON/OFF VOLUME: Combined on/off pushbutton switch and rotary volume con-
trol for the headphones output.
2 HP OUT: TRS ¼" jack for connecting a pair of headphones. The signal is iden-
tical to the audio signal fed to the RF section.
3 SETUP: Adjusts the transmitter parameters.
4 Color code: Replaceable ring for marking the transmitter.
5 Display: Refer to section 2.4.2 below.
AKG IVM 4
2 Description
5
2 2 . . 1 1 I I n n t t r r o o d d u u c c t t i i o o n n
2 2 . . 2 2 U U n n p p a a c c k k i i n n g g
2 2 . . 3 3 O O p p t t i i o o n n a a l l
A A c c c c e e s s s s o o r r i i e e s s
2 2 . . 4 4 S S S S T T 4 4
S S t t a a t t i i o o n n a a r r y y T T r r a a n n s s m m i i t t t t e e r r
2 2 . . 4 4 . . 1 1 F F r r o o n n t t P P a a n n e e l l
Fig. 1: Transmitter front
3 4
panel and display.
Refer to fig. 1.
27