Dmx Linking; Master/Slave Connection; Mounting Diagram - Chauvet Professional OVATION F-265WW Schnellanleitung

AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
Power Linking
You can link up to 7 Ovation F-265WW products at 120 V, 12 products at 208 V, or 13 products at 230 V. Never exceed
this number. Power linking cords can be purchased separately.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
Replacing the Fuse
1. Disconnect this product from power.
2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.

DMX Linking

The Ovation F-265WW will work with a DMX controller using a 3- or 5-pin DMX data connection. A DMX Primer is
available from www.chauvetprofessional.com.
DMX Connection
The Ovation F-265WW uses a 3- or 5-pin DMX data connection for its DMX personalities: 1Ch: 8bit Dim, 2Ch: 16bit
Dim, 2Ch: 8bit Dim+Zoom, and 5Ch: 16bit-Full. See the User Manual for information about connecting and configuring
the product for DMX operation.

Master/Slave Connection

The Ovation F-265WW uses the DMX data connection for its Master/Slave mode. See the User Manual for information
about connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. The Ovation F-265WW supports RDM protocol that allows feedback to monitor temperature
and changes to DMX Address, DMX Personality, Dimmer Mode, and LED Frequency menu options. Download the
User Manual from www.chauvetprofessional.com
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our CHAUVET Professional line of mounting
clamps, go to http://trusst.com/products.

Mounting Diagram

Safety cable
Secure the safety
cable using the
passageway on
the back of the
product
Ovation F-265WW QRG Rev. 4
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
for more details.
Safety Notes. Use at least one mounting point per product. Make sure the
Wire (Europe)
Brown
Blue
Green/Yellow
Mounting clamp
EN
Screw Color
Yellow/Brass
Silver
Green
2