Storage; Recommissioning; Disposal - Brill MS 254 B Bedienungsanleitung

en
1. Completely remove the fuel cap.
2. Empty the remaining fuel into a suitable con-
tainer.
3. Pull the filter out of the tank with a wire hook.
4. Remove the filter with a twisting motion.
5. Exchange the filter.
CAUTION!
Risk of injury from rotatingcutting
head!
Only adjust Bowden cables with the
engine switched off.
Only check the function with the
strimmer lying down.
Sharpening the string cutter blade
1. Remove the cutting blade from the guard.
2. Clamp the cutting blade in a vice and sharpen
it with a flat file.
File in one direction only!
Spark plug
1. Tighten the spark plug with a torque of
12-15 Nm.
2. Push the spark plug connector onto the spark
plug.
Spark plug gap = 0,635 mm [0.025"] .
see Figure 8
Carburettor adjustment
The carburettor is optimally adjusted at the fac-
tory.
MS 254 B
Adjusting the Bowden cables
see Figure 9
The Bowden cables of your strimmer are fac-
tory-adjusted. If the position of the "bike grip"
handle is significantly changed, this can cause the
Bowden cable to stretch, resulting in malfunction-
ing of the throttle.
If the cutting head does not come to a standstill
after the strimmer has been started and the half
throttle lock has been released, the Bowden cable
must be adjusted by means of the adjusting screw
(1). Correct functioning of the throttle is then as-
sured once again.
24

STORAGE

CAUTION!
Risk of fire and/or explosion!
Do not store the machine in the vicinity
of naked flames or heat sources.
Empty the fuel tank before long periods of
storage (over the winter).
Only empty the fuel tank outdoors.
Allow the engine to cool down before storage.
Steps
1. Empty the fuel tank.
2. Start the engine and let it idle until it stops.
3. Let the engine cool down.
4. Loosen the spark plug with a spark plug so-
cket.
5. Pour a teaspoon of 2-stroke oil into the com-
bustion chamber.
6. Pull the starter cord slowly several times to
distribute the oil in the interior of the engine.
7. Insert the spark plug again.
8. Thoroughly clean and service the device.
9. Store the device in a cool dry place.
CAUTION!
Fire hazard!
Do not store fuelled machine in buildings
where the petrol fumes might come into
contact with naked flames or sparks!

RECOMMISSIONING

1. Remove the spark plug.
2. Quickly pull the starter cord to remove leftover
oil from the combustion chamber.
3. Clean the spark plug and check the spark
gap. Replace if necessary.
4. Prepare the device for operation.
5. Fill the tank with the correct fuel/oil mixture.

DISPOSAL

Do not dispose of old
equipment,batteries or accumulators
as householdwaste!
Product, packaging, and accessories
were made with recyclable materials, and
should be disposed of accordingly.
Maintenance and care
MS 254 B / LT 254 D