English - Kenwood BL730 Handbuch

Use your blender for soups, sauces,
drinks, pâtés, mayonnaise, dressings
etc.
before using your Kenwood
appliance
●
Read these instructions carefully and
retain for future reference.
●
Remove all packaging and any
labels.
safety
●
Allow all liquids to cool to room
temperature before placing them in
the blender.
●
Switch off and unplug:
before fitting or removing parts
● ●
after use
● ●
before cleaning.
● ●
●
Keep hands and utensils out of the
blender when it's on the power unit.
●
Don't touch the sharp blades.
●
Never use a damaged machine. Get
it checked or repaired: see 'service'.
●
Never use an unauthorised
attachment.
●
Never leave the machine on
unattended.
●
When removing the blender from the
power unit:
wait until the blades have
● ●
completely stopped;
don't accidentally unscrew the
● ●
goblet from the blade unit.
●
Never run the blender empty.
●
Always unplug your blender
when not in use.
●
Only operate the blender with the lid
in place.
●
Do not let infirm people use the
appliance without supervision.
●
Do not let children use or play with
the appliance.
●
Only use the appliance for its intended
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with
these instructions.

English

before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of the machine.
●
This machine complies with
European Economic Community
Directive 89/336/EEC.
before using for the first time
1 Wash the parts: see 'cleaning'.
key
blender
filler cap
dual action locking lid
lid seal
goblet
sealing ring
blade unit
base
speed control
power unit
cord storage
to use your blender
1 Fit the sealing ring - ensuring the
seal is fully located under the rim of
the blade unit. Leaking will
occur if the seal is damaged
or not fitted correctly.
2 Clip the blade unit into the base.
3 Screw the goblet onto the blade
unit.
4 Put your ingredients into the goblet.
5 Push the lid seal onto the underside
of the lid.
6 Fit and lock the filler cap in the lid,
by turning one position
2
.