Panasonic KX-TG9120EX Bedienungsanleitung Seite 55

TG9120_40_50EX(e).book Page 55 Monday, August 7, 2006 3:52 PM
L This number is used by the handset
as a reference only.
5
Press and hold {x} on the base unit for
about 3 seconds, until the registration
tone sounds.
L If all registered handsets start ringing,
press {x} to stop, then repeat this
step.
L After pressing {x}, the rest of this
procedure must be completed within 1
minute.
6
Wait until "Enter Base PIN" is
displayed, then enter the base unit PIN
(default: "0000"), then press L.
L When the handset has been
registered successfully, w will stop
flashing. If keytones are turned on
(page 31), a confirmation tone will be
heard.
Selecting a base unit
When "Auto" is selected, the handset will
automatically use any available base unit it
is registered to. When a specific base unit is
selected, the handset will make and receive
calls using that base unit only. If the handset
is out of range of that base unit, no calls can
be made.
1
J (centre of joystick) i m i L
2
"Select Base" i L
3
Select the desired base unit number, or
"Auto". i L
L The handset starts searching for the
base unit.
Cancelling a handset
A maximum of 6 handsets can be registered
to a base unit. A handset can cancel its own
registration (or the registration of another
handset) that is stored in the base unit. This
will allow the base unit to "forget" the
handset.
1
J (centre of joystick) i L i L
Multi-unit Operation
2
Enter "335".
3
"Cancel Handset" i L
L All handsets registered to the base
unit are displayed.
4
Select the handset(s) you want to
cancel. i t
L The selected handsets are indicated
by a "Q".
L To cancel a selected handset, press
t again.
5
L i "Yes" i L
L "Please Wait..." will be displayed
and a long beep will sound.
L The handset does not beep when
cancelling its own registration.
6
{ih}
Cancelling a base unit
A handset can be registered to a maximum
of 4 base units. A handset can cancel a base
unit that it is registered to. This allows the
handset to "forget" the base unit.
1
J (centre of joystick) i m i L
2
"Registration" i L
3
Enter "335".
4
"Cancel Base" i L
5
Select the base unit(s) you want to
cancel. i t
L The selected base unit number(s) are
indicated by a "Q".
L To cancel a selected base unit
number, press t again.
6
L i "Yes" i L
L A long beep will sound.
7
{ih}
Note:
L To register the handset to another base
unit or to the same base unit again, see
manual registration (page 54).
55