When To Change The Dustbag; How The Dustbag Change Indicator Works; How To Replace The Dustbag - Miele Complete C2 SF 3 Serie Gebrauchsanweisung

filter. Original Miele multi-packs contain
16 dustbags, four AirClean exhaust fil-
ters and four motor protection filters.
Original Miele exhaust filters can also
be purchased separately from your
Miele Dealer or from Miele. Please
quote the model number of your va-
cuum cleaner when ordering to make
sure you get the correct filter. You can
also order all accessories via the Miele
webshop.
When to change the dustbag (dia. 30)
Change the dustbag when the colour
marker in the dustbag change indicator
turns red, or sooner if it is no longer ef-
fective (see possible reasons for this
below).
Miele dustbags are disposable and
designed for single use only. Dispose
of the dustbag when full. Do not at-
tempt to reuse. Blocked pores in
used dustbags will reduce the suc-
tion power of the vacuum cleaner.
To check the dustbag change indic-
ator
 Attach the standard adjustable floor-
head to the vacuum cleaner.
 Switch the vacuum cleaner on and
select the highest power setting.
 Lift the floorhead off the floor a little.
How the dustbag change indicator
works
The dustbag change indicator is set for
normal household dust. This generally
contains a mixture of dust, hair,
threads, carpet fluff, grit etc.
However, if the cleaner has been used
to vacuum up fine dust, such as plaster,
brick dust, cement or flour, the pores of
the dustbag will become blocked very
quickly.
This affects the air permeability of the
bag, and the marker will indicate that
the bag is "full" even when it is not. If
this happens you must still change the
dustbag because suction power will be
greatly reduced by blocked pores in the
dustbag.
If, on the other hand, a large amount of
hair and carpet fluff which typically con-
tains a lot of air is vacuumed up, the in-
dicator may fail to react even though
the bag is full. You should still change it.
Both these extremes can occur.

How to replace the dustbag

(dia. 31 + 32)
 Press the release buttons at the side
of the hose connector, and lift the
hose from the socket (dia. 02).
 Lift the release catch for the dust
compartment lid and raise the lid as
far as it will go (dia. 13).
The dustbag has a flap which closes
automatically when the dust compart-
ment lid is raised to prevent any dust
escaping.
 Pull the dustbag out by the grip on
the collar.
 Fit the new dustbag into the holder as
far as it will go. Leave it folded up
when you take it out of the box.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
en
41