Service- And Maintenance Intervals; Tire Width And Pressure; Possible Gear Ratios - Schindelhauer Bikes Viktor Benutzerhandbuch

Service- and maintenance intervals

After an initial break-in period, your bike will have to be maintained and
serviced in regular intervals and certain components will have to be
checked and/or replaced. Ideally, your Schindelhauer bikes dealer should
EN
perform this maintenance. The intervals stated in the following table are
meant to function as a guide for people that travel an annual distance of
Component Task/Activity
Check tire pressure
Tires Skid depth control
Check for ruptures on the sidewall
Brakes Control brake pad thickness
Brake cables/-lines Visual check
Check
Aluminum fork
Replace
Visual check
Gates belt
Check tension
Check bearing play
Single speed-hub
Grease freehub body
Check bearing play
Inner bearing
Grease (frame thread)
Check bearing play
Pedals
Control grip tape/replace if necessary
Crank Check and retighten
Paint finish Conserve
Control true run
Wheels/spokes
Check spoke tension
Check for bends and cracks
Handlebars/stem
Replace
Headset bearing Check bearing play
Metallic surfaces Conserve (exception: brake disks!)
36
1500-2500 km with their bike. More frequent use or bad street conditions
mean these intervals have to be shortened accordingly.
o With adequate technical- and mechanical comprehension, you
may carry out these operations on your own.
x Your Schindelhauer dealer should carry out these operations.
Before every ride Monthly Annually Other interval
o
o
o
o
x
x min. biannual
x after crash
o
o
x
x
x
x
o
o
x
o
o
o
x min. biannual
x after crash
o
o
Component Task/Activity Before every ride
Axle bolts Beleuchtung * Check/retighten Kontrollieren o
Nuts and bolts Check/retighten
Valves Check fit
Seat post Grease clamped connections
Saddle Leather care (for leather saddles)

Tire width and pressure

Model Tires Nominal width
Siegfried Road Continental Grand Prix Classic 25 mm
Viktor/Siegfried Continental Grand Prix 28 mm
The maximum tire width allowed for the Viktor, Siegfried,
i
and Siegfried Road models is 32mm (measured width). The

Possible gear ratios

Front sprocket Rear sprocket Gear ratio Number of
teeth (belt)
70* 20 3.50 120
70* 22 3.18 120
60 20 3.00 115
60 22 2.73 115
55 22 2.50 113
55 24 2.29 113
50 24 2.08 111
Monthly Annually Other interval
o
o
o
o
o
recommended tire pressure Maximum tire pressure
6,0 - 7,5 bar 8,5 bar
5,5 - 7,0 bar 8,0 bar
nominal width stated on the sidewall of the tire and the actual
measured width may differ depending on the manufacturer.
* 1.5 mm spacers required between pulley and crankg
Bold print = default gear ratio
You may order pulleys through Gates or Schindelhauer
i
Bikes. Let a recommended dealer carry out the modifi-
cation as special tools are needed.
EN
37